FieldServer FPCN380717 Serial ProtoNode SMC Heart of

Protonode Fieldserver. FieldServer FPCN380717 Serial ProtoNode SMC New Open The ProtoNode is an external, high-performance, low-cost building automation and industrial control IIoT gateway for original equipment manufacturers (OEMs. 79 Appendix E-4: BACnet: Setting Network_Number for more than one ProtoNode on Subnet.82 Appendix E-5: LED Diagnostics for Modbus RTU Communications Between ProtoNode and

Page 5 INTRODUCTION Universal Gateway (ProtoNode) is an external, high performance Energy Management System (EMS) multi-protocol gateway that uses the FieldServer ProtoNode Technology SMC-insidesales@msasafety.com www.sierramonitor.com T18410 3/20 Benefits of the SMC Cloud • Registering ProtoNode BMS/IoT Gateways on MSA

SMC SIERRA MONITOR FIELDSERVER PROTONODE GATEWAY RECOVERY MANUAL

It has been pre-programmed to communicate between boiler devices listed in Table 1-1 and LonWorks®. Contents About the MSA FieldServer ProtoNode Certification BACnet/LonWorks Setup through ProtoNode Features Installation Steps for the Customer Record Identification Data Configure the DIP Switches 2.4.1 Setting the Node/ID Device Instance (DIP Switch A0 - A7) 2.4.2 Setting the Serial Baud Rate (DIP Switch B0 - B3) 2.4.3 Select and Load. The FieldServer ProtoNode is a low-cost, high-performance gateway option for OEMs in need of a secure interface with their Building Management Systems (BMS)

FieldServer FPCN380717 Serial ProtoNode SMC New Open. The ProtoNode gateway provides immediate IoT remote monitoring capabilities for all devices in the field Page 5 INTRODUCTION Universal Gateway (ProtoNode) is an external, high performance Energy Management System (EMS) multi-protocol gateway that uses the FieldServer ProtoNode Technology

MSA FieldServer™ Gateway’s Driver Is ODVA® Certified IoT. Contents About the MSA FieldServer ProtoNode Certification BACnet/LonWorks Setup through ProtoNode Features Installation Steps for the Customer Record Identification Data Configure the DIP Switches 2.4.1 Setting the Node/ID Device Instance (DIP Switch A0 - A7) 2.4.2 Setting the Serial Baud Rate (DIP Switch B0 - B3) 2.4.3 Select and Load. the ProtoNode automatically builds and loads the appropriate configuration